Click to enlarge
Seated row handle chrome steel with molted rubber grip $25.00
Back to products
Cable 5mm black outer 7 core x 19 strands x 100 meters $335.00

Build your – Custom Gym Cable

$40.00

Step 1: measure your cable
How to measure your cable. Before removing your existing cable it is highly recommended that you photograph or draw a diagram of how the cable is routed in the machine.
Once you have taken notice of the routing remove any attachments on the cable that will stop you from pulling the cable from the machine, you may have to remove pullies if attachments cannot be removed. NOTE: Before removing the cable from the machine observe any dangers that may arise if the cable tension is removed. If the cable has been broken and full length cannot be achieved because the cable is distorted or lost, a length of string routed where the cable was can be used to achieve the cable length, care and thought should be taken when using this method as a last resort to find the cable length. Once cable has been removed lay it out on a flat surface holding the cable taut measuring the length in millimeters using the below diagram as a guide. Note: with ball stopper ends its important to measure inside as shown below.
Step 2: Select your cable
There are a number of cable diameters used in gym equipment, its important to select the correct diameter, most cables are normally 4mm, 5mm, or 6mm outer diameter. NOTE: Choose the diameter that best suits your cable, there maybe some very slight variances of .5mm due to cables been made in metric and imperial grades.
Black 5mm x 7X19 STRANDS
Black 6mm x 7X19 STRANDS
4mm black ultra
Step 3: select cable end #1
NOTE: If you cannot find the end to match your cable contact us for alternatives
END A - Thimble 40mm - Ball stopper
END B - Thimble 25 mm - Ball stopper
END C - thimble
END D - through hole bolt 12mm
END E - through hole bolt 14mm
END F - through hole bolt 16mm
END G - through hole & NUT 1/2inch
END H - though hole & nut 16mm
END I - eyelet and 40mm Ball stopper
END J - eyelet and 25mm Ball stopper
END K - Eyelet
END L - cable hanger
END M - ball shank 9mm
END N - ball shank 14mm
END O - cut end
END P - Threaded shaft 10mm
END Q - clevis joint 10mm bore, 6mm slot
Step 4: select cable end #2
NOTE: If you cannot find the end to match your cable contact us for alternatives
END A - Thimble 40mm - Ball stopper
END B - Thimble 25 mm - Ball stopper
END C - thimble
END D - through hole bolt 12mm
END E - through hole bolt 14mm
END F - through hole bolt 16mm
END G - through hole & NUT 1/2inch
END H - though hole & nut 16mm
END I - eyelet and 40mm Ball stopper
END J - eyelet and 25mm Ball stopper
END K - Eyelet
END L - cable hanger
END M - ball shank 9mm
END N - ball shank 14mm
END O - cut end
END P - Threaded shaft 10mm
END Q - clevis joint 10mm bore, 6mm slot
NOTE: If you cannot find the end to match your cable contact us for alternatives
Step 5: enter length in millimeters as per diagram
Enter length in millimeters.
Enter length in millimeters.
Enter length in millimeters.
Product total
Options total
Grand total
Category:
Additional information
Weight 10 kg
Dimensions 10 × 10 × 10 cm
Shipping & Delivery